This assembly is not for the faint of heart, it is not for those that do not like scraped knuckles or are concerned with their manicures. Today you prove your worth in the evolution of man. You are going to need a 17mm & 14mm to loosen the axle but don't do any of this until you have used the 8mm to undo the brake housing assembly positioning bolt. This is the key to aligning and holding alignment for the belt tension and pulley belt. A 10mm nut driver is very handy for positioning the axle tensioners in perfect alignment and for installing the HTD belt without side loads and correct run out. After you get all of the geometry and tension correct, take a deep breath, puff out your chest and grunt with satisfaction. This is not for the lilly livered to attempt. The whole shebang that includes the brake, tire and tube is es7070192 and can be had for a mere $5 bucks more. For the $5 bucks more you get a tire, a tube, a brake and the whole thing put together. So what is it going to be? Brains or Brawn? Makes a great spare! |